Fixed a bug which could result in an empty or incomplete toolpath for Flow.This gives fewer and more uniform linking paths. Added Blend toolpath joining in more cases if the endpoints are aligned.Fixed possible small gouges in Blend, Flow and Multi-axis contour.Fixed a failed toolpath calculation in Blend which occured in some instances where machining boundaries were used.Fixed a possible holder gouge in Blend and Flow strategies with enabled "Trim" option in holder protection.When the toolaxis hits the limit, it will decelerate to a stop rather than stopping suddenly. Added damping for toolaxis limits in Blend and Flow with a non ball tool.Fixed an issue in Flow operations where the toolpath might not be machined if the tilt angle was exceeded on a machine with limited axial motion.Fixed a case when Contour2D could fail to generate toolpath for narrow slots with ramp linking.Fixed a bug when "finishing feedrate" might not apply to last finishing path.Fixed possible linking issues in Contour2D when input contours contain arcs with the same center.Installation WHAT’S NEW The following changes have been made in the current update (2024):
This document covers the following HSMWorks products:
0 kommentar(er)
